Essick EP9R 500 Owner's Manual download pdf (Page 4)

NOTES ON LOCATION:

In order to get the most effective use from your humidifier, it is important to position

the unit where the most humidity is needed or where the moist air will be circulated

throughout the house such as near a cold air return. If the unit is positioned close to

a window, condensation may form on the window pane. If this occurs the unit

should be repositioned in another location.

Place humidifier on a flat level surface. Do

NOT position the unit directly in front of a hot

air duct or radiator. Do NOT place on soft

carpet. Due to release of cool, moist air from

the humidifier, it is best to direct air away from

thermostat and hot air registers. Position

humidifier next to an inside wall on a level

place at least 2 inches away from the wall or

curtains.

Be sure that the humidistat, which is located

on the power cord, is free from obstruction

and away from any hot air source.

Locate nearest 120V A.C. wall socket in the location desired, preferably on inside

wall. With the humidifier in the desired location, route the electrical cord safely so no

one will trip or upset the humidifier. Plug unit in.

After the humidifier is positioned where it will be operating you are ready to fill the

humidifier.

ASSEMBLY

1) Unpack humidifier from carton. Remove all packaging materials.

CASTERS

2) Lift chassis off of base and set aside. Remove the parts bag, wick/ wick

retainer and float from base.

3) Turn the empty base upside down. Insert each caster stem into a caster hole on

each corner of the humidifier bottom. The casters should fit snugly and be

inserted until the stem shoulder reaches the cabinet surface. Turn the base right

side up.

FLOAT

4) Install float by separating the two

flexible halves of retainer clip,

inserting the float into the clip and

securing it into the base.

EVAPORATIVE WICK

5) Ensure the 1043 Superwick is

installed in the two-part wick retainer

base in the base of the humidifier

6) Position the chassis over the base

frame and press it onto the base

firmly until it is in place.

CAUTION: Ensure the chassis is placed

on the base with the float facing forward

to prevent damage to components.

Float

Wick Retaine

No. 1043

Wick

FRONT

2 inches

1 2 3 4 5 6 7 8 9 ... 35 36

Comments to this Manuals

No comments

Essick EP9R 500 Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Dehumidifiers Essick EP9R 500