Essick EP9R 500 Owner's Manual download pdf (Page 7)

FAN SPEED

2) The Speed button controls

the variable speed motor.

Nine speeds provide precise

fan control. Press the power

button and select fan speed:

F1 through F9 proceeding

from low to high speed.

The fan speed will display on

the control panel as the

speeds are stepped through.

NOTE: When excessive condensation exists, a lower fan speed setting is

recommended.

HUMIDITY CONTROL

NOTE: The EP9 500 / EP9R 500 units have an automatic humidistat located on the

cord that measures the relative humidity in the room. When the selected humidity

level drops 3% below the relative humidity, the humidifier cycles on and off as

required to maintain the selected setting.

3) At initial startup the

relative humidity of

the room will be

displayed.

Each successive

push of the Humidity

Control Button will

increase the setting

in 5% increments. At

65% set point, the

unit will operate

continuously.

OTHER INDICATIONS

4) This humidifier has a check filter reminder timed to appear after

720 hours of operation. When the Check Filter (CF) message is

displayed, disconnect the power cord and check the condition of

the filter. The CF function is reset after plugging the unit back in.

5) When the unit is out of water, a flashing F will display on the display

panel.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

No comments

Essick EP9R 500 Owner's Manual Page 7